Mini Buffs, Goblets, rolls and Felt Bobs
Yellow Treated Cloth Buffing Rolls
Industrial quality cloth buffing rolls are great for
reaching deep tight areas and they work faster than felt bobs.
For use with any of our buffing compounds.
For the best results and longest wear, do not exceed maximum RPM's.
Maximum RPM's for 3/4" rolls, 6,000, #CR-34, $2.29 ea.
Due to the heavier weight of cloth rolls over abrasive rolls, they need a thicker pilot shaft.
The pilot shaft is the part of the mandrel that goes inside the rolls for supporting it.
Our abrasive rolls use a 1/8" pilot shaft and our cloth rolls use a 3/16" pilot shaft.
Use #M-17, 1/4" shank mandrel with 3/16" pilot shaft for cloth rolls, $4.29 ea.
Yellow Treated Mini Buffs
last up to 3 times longer than standard cotton buffs.
The same industrial quality treated buffs we used in our polishing shop for years.
We use a firm Yellow treatment as apposed to other soft yellow treatments.
These Treated buffs have become our most popular wheels for buffing in those
tight areas on any type of metal. The construction and yellow treatment
buffs to run up to a maximum of 23,000 RPM's. For use with any of our buffing compounds.
For 1/8" hand grinders use the #TY-1, $1.99 and #MN-1, $2.99 with 1/8" shank.
For 1/4" hand grinders use the #TY-2, $1.99 and #MN-2, $3.50 with 1/4" shank.
For 1/4" hand grinders use the #SB-2, $2.79 and #MN-4, $3.99 with 1/4" shank.
Tapered Goblet Buffs and Mandrels
Work fast in semi tight areas with excellent
compound retention and long wearing cloth.
For use with any of our buffing compounds. Max. RPM's 12,000.
Also used for making abrasive (set-up) polishing wheels.
2-1/2" at base, 1" at tip and 2-1/2" long, #TG-25, $16.99
. 2" at base, 1" at tip and 2" long, #TG-2, $15.99
Mandrels for tapered goblet buffs are for non threaded shaft sizes of 1/2" or 5/8". Secured to shaft with two set screws:
For your 1/2" non threaded shaft, right hand mounting only, order #TS-4, $5.99
For your 5/8" non threaded shaft, right hand mounting only, order #TS-5, $5.99
For hand held power tools we also have a 1/4" shank tapered mandrel #TS-14, $5.49
Felt Bobs, Mounted & Unmounted
These are industrial quality felt bobs, not synthetic.
For use with any of our compounds for reaching the real tight areas, on most any type of metal.
Unmounted Bob 1" x 2", #2112, 5.99
. Mandrel for #2112 with 1/4" shank #MN-6, $3.99
Mounted Bob 1/2" x 1" x 1/8" shank. #2118, $3.99
. Mounted Bob 3/4" x 1-1/2" x 1/4" shank, #2134, $6.25
Warning: do not exceed maximum RPM ratings as listed below.
#2112 is 14,000, best results at 12,000.
#2118 is 25,000, best results at 20,000. #2134 is 22,000, best results at 18,000.